Trim excess material

Description

Trim surplus material of fabric such as fiberglass mats, cloth, plastics or rubber.

Alternative labels

take away excess material
take off excess parts
trim material in excess
trim material
remove excess material
cut off excess material

Skill type

skill/competence

Skill reusability level

cross-sector

Relationships with occupations

Essential skill

Trim excess material is an essential skill of the following occupations:

Injection moulding operator: Injection moulding operators operate and monitor injection moulding machines, in order to cast products from thermoplastic materials. They regulate the temperature, pressure, and volume of plastic, according to pre-defined specifications. Injection moulding operators also remove finished products and cut-away excess material, using a knife or other hand tools.
Fibreglass machine operator: Fibreglass machine operators control and maintain the machine that sprays a mix of resin and glass fibers onto products such as bathtubs or boat hulls to obtain strong and lightweight composite end-products.
Blow moulding machine operator: Blow moulding machine operators operate and monitor blow moulding machine to mould plastic goods, according to requirements. They regulate temperature, air pressure and volume of plastic, according to specifications. Blow moulding machine operators remove finished products and cut away excess material, using a knife. They regrind surplus material and rejected workpieces for reuse, using a grinding machine.
Glass beveller: Glass bevellers measure, cut, assemble and install flat glass and mirrors. They also load and unload glass, mirrors and equipment, drive to installation sites, install metal or wood frameworks that need to be fitted with glass, and work according to client specifications.

Optional skill

Trim excess material is optional for these occupations. This means knowing this skill may be an asset for career advancement if you are in one of these occupations.

Fiberglass laminator: Fiberglass laminators mould fiberglass materials to form hulls and boat decks. They read blueprints and use hand and power tools to cut the composite materials. They apply waxes and lacquers, and prepare surfaces for the placement of fiberglass mats. They use resin-saturated fiberglass to bond wood reinforcing strips to cabin structures and decks. They also prepare materials exposing those to the right temperature. They check finished products for defects and make sure they comply with the specifications.

Envelope maker: Envelope makers tend a machine that takes in paper and executes the steps to creat envelopes: cut and fold the paper and glue it, then apply a weaker food-grade glue to the flap of the envelope for the consumer to seal it.
Cake press operator: Cake press operators set up and tend the hydraulic presses that compress and bake plastic chips into cake moulds to produce plastic sheets. They regulate and adjust the pressure and temperature.
Drapery and carpet cleaner: Drapery and carpet cleaners clean draperies and carpets for their clients by removing stains, dust or odors. They do this by applying chemical and repellent solutions and with the use of brushes or mechanical equipment.

 


 

References

  1. Trim excess material – ESCO

 

Last updated on September 20, 2022